E20
Liebherr
Excessive Vibration / Suspension Fault
Washer-dryer shows E20 and may stop during high-speed spin.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Worn shock absorbers, Broken suspension springs, Transit bolts not removed, Machine not level
How to Fix / Troubleshooting
Safety first: Unplug the appliance before tipping or moving it.
- Check transit bolts: If the machine is newly installed, ensure all Liebherr shipping bolts at the rear have been removed according to the installation manual.
- Level the appliance: Adjust the front and rear feet so the washer-dryer is stable and does not rock. Use a spirit level.
- Inspect shocks and springs: Remove side or rear panels to inspect suspension components. Replace leaking or weak shock absorbers and any broken springs.
- Load distribution: Advise users to avoid very small or very large single-item loads that can cause imbalance.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Shock Absorber Set
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements