Washer-dryer shows condensation or steam around the control panel or door during drying, with slight moisture escaping.

Safety first: Surfaces may be hot after drying; allow to cool before touching seals.

• Check door seal contact: Inspect the gasket for deformation or gaps, especially at the top. Replace if it does not press firmly against the door glass.
• Clean condenser and vents: Ensure the condenser and all air passages are clean to reduce internal steam pressure.
• Reduce load size: Dry smaller loads to reduce steam volume and improve condensation efficiency.
• Inspect door hinges: Tighten loose hinges so the door closes evenly against the seal.