Washer-dryer combo displays F32 and may not fill or may stop during fill.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Open or shorted pressure switch, disconnected pressure hose, wiring fault to control, defective control input

Safety first: Unplug the unit and ensure the drum is empty before working on the pressure system.

Step-by-step checks:

1. Inspect pressure hose and switch: Follow the steps under F10 to verify hose integrity and switch operation.
2. Electrical test: With the switch disconnected, measure resistance between its terminals while applying and releasing pressure. Replace if readings do not change as expected.
3. Harness check: Inspect and reseat the connector at the control board. Repair any damaged wires.

Medium 3/5

Water Level Pressure Switch

Check Price on Amazon

We may earn a commission from links on this page.