Washer-dryer combo shows F35 and may not fill or may abort cycles.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Failed analog pressure sensor, blocked pressure hose, wiring fault to sensor, control board misinterpretation

Safety first: Unplug the unit and ensure the drum is empty.

Step-by-step checks:

1. Locate analog pressure sensor: Usually a small rectangular or round device with a hose and multiple wires, mounted near the control board.
2. Inspect hose: Check for kinks, blockages, or water in the hose. Clear or replace as needed.
3. Wiring check: Inspect the sensor connector and harness for damage. Reseat the connector.
4. Replace sensor: If hose and wiring are good and F35 persists, replace the analog pressure sensor with the correct Maytag part.

Medium 3/5

Analog Pressure Sensor

Check Price on Amazon

We may earn a commission from links on this page.