Maytag Door Lock Stuck Closed

Washer-dryer combo door is locked and will not open after cycle completion; no error code displayed.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Door lock mechanism jammed, control not sending unlock signal, residual water or high temperature in drum, swollen door gasket pressing on latch

How to Fix / Troubleshooting

Safety first: Unplug the unit. If the drum is full of hot water, allow it to cool before attempting manual release.

Step-by-step checks:

  • 1. Wait a few minutes: Some models delay unlocking until the drum stops and water cools.
  • 2. Manual release: Access the door lock from the front by removing the lower panel or pulling back the door boot. Use the manual release tab or lever on the lock to open the door.
  • 3. Inspect lock and strike: Check for physical damage or misalignment. Replace the door lock assembly if it sticks or fails intermittently.
  • 4. Control check: If the lock is mechanically free but does not receive an unlock signal, further diagnosis of the control board is needed.
Advertisements

Repair Difficulty

Medium 3/5

Required Part

Door Lock Assembly
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements