Washer-dryer combo leaves clothes soaking wet at the end of the cycle.

Safety first: Unplug the unit before accessing internal components. Water may be present in hoses.

Step-by-step checks:

• 1. Run drain and spin: Select a drain/spin cycle with no extra rinse. If the drum drains but does not reach high speed, continue with checks.
• 2. Check for error codes: Even if not displayed, enter diagnostic mode (per tech sheet) to see stored codes like F21 or F25 that can guide you.
• 3. Inspect drain system: Clean the pump filter and check the drain hose for blockages as described under F21.
• 4. Check belt and motor: Inspect the drive belt for wear and tension. Replace if loose or glazed. Verify the motor runs smoothly.
• 5. Pressure switch: If the control thinks water is still present, it may not allow high-speed spin. Inspect the pressure hose and switch as under F10.