Miele
Poor Spin Extraction
Washer-dryer leaves clothes very wet after spin, even though cycle completes
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Blocked drain pump or filter, Partially blocked drain hose, Worn drive belt slipping, Unbalance detection reducing spin speed
How to Fix / Troubleshooting
Safety first: Unplug the appliance and be prepared for water when opening the pump filter.
- Clean pump filter: Open the service flap and remove the pump filter. Clear any lint or debris.
- Check drain hose: Ensure the hose is not kinked and is installed at the correct height. Flush with water if necessary.
- Run spin-only: Try a spin-only program with a smaller, well-distributed load.
- Inspect drive belt: Remove the rear panel and check the belt for looseness or glazing. Replace if worn.
- Suspension check: If the machine vibrates heavily, repair suspension components to allow full spin speed.
Advertisements
Repair Difficulty
Medium
3/5
Advertisements