Washer-dryer stops mid-cycle and does not progress, but no error code is shown

Safety first: Unplug the appliance before internal inspection.

• Note where it stops: Observe whether the stall occurs during fill, heat, wash, drain, or spin. This helps pinpoint the subsystem involved.
• Basic checks: Clean the pump filter, ensure proper drainage, and verify water inlet and heating as described in other entries.
• Reset machine: Cancel the program, switch off, unplug for several minutes, then restart a simple cycle.
• Inspect pressure hose: If stalling occurs around water level changes, clean the pressure hose and chamber.
• Professional diagnosis: If the issue persists without a code, a technician may need to read stored fault logs and test sensors.