E19
New World
Relay / Triac Stuck or Open Fault
Washer-dryer shows E19 and may stop heating or drying; sometimes intermittent.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Stuck heater relay on PCB, Failed motor triac, Dry solder joints on control board, Overheated PCB tracks
How to Fix / Troubleshooting
Safety: Unplug the appliance. PCB work should be done only by qualified personnel.
- Observe symptoms: Note whether the issue affects wash heating, drying, or motor operation. This helps identify which relay/triac is involved.
- Visual PCB inspection: Access the main control PCB and look for discoloured or cracked solder joints around relays and triacs. Also check for burnt tracks.
- Reseat connectors: Ensure all harness connectors to the PCB are fully seated and not heat-damaged.
- Replace PCB: If a relay or triac is suspected faulty and you are not equipped for component-level repair, replace the entire PCB with the correct New World part. This is generally a professional repair.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Main Control PCB
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements