E14
Roborock
Dryer System Transition / Diverter Valve Fault (Condenser Type)
Washer-dryer combo displays E14; cycle stops when switching from wash to dry
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Stuck Roborock air diverter valve, Blocked condenser water spray nozzle, Faulty diverter valve actuator, Control board logic error
How to Fix / Troubleshooting
Safety first: Disconnect power and close water supply taps before accessing internal components.
- Power reset: Unplug for 10 minutes and retry a wash+dry cycle to rule out a transient control error.
- Access diverter assembly: Remove the top or rear panel to locate the Roborock air/water diverter valve used for condenser drying.
- Inspect for blockage: Check hoses and the condenser spray nozzle for scale or lint buildup. Clean with warm water and a soft brush.
- Check actuator movement: Manually move the diverter (if possible) to ensure it is not mechanically jammed.
- Replace if necessary: If the actuator does not respond during cycle transitions and wiring is intact, replace the Roborock diverter valve assembly.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Roborock Condenser Diverter Valve Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements