Roborock Poor Spin Extraction

Washer-dryer combo leaves clothes very wet at the end of the cycle, even though spin completed

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Spin speed set too low, Unbalanced load causing reduced spin speed, Partially blocked Roborock drain pump or hose, Worn motor or belt slipping

Safety first: Unplug before accessing filters or internal parts.

Check settings: Confirm the selected program uses high spin speed and that spin is not disabled.
Run extra spin: Select a separate spin-only cycle with maximum speed.
Clean drain system: Open and clean the Roborock drain pump filter and check the drain hose for partial blockages.
Inspect belt (if applicable): Remove the rear panel and check the drive belt for looseness or glazing. Replace if slipping.

Medium 3/5

Roborock Drain Pump Assembly

Check Price on Amazon

We may earn a commission from links on this page.