8E
Samsung
Vibration Sensor Error
Washer-dryer combo displays 8E and may vibrate abnormally or fail to spin properly.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Faulty vibration sensor (VRT sensor), Loose sensor mounting, Damaged sensor wiring, Control board misreading vibration data
How to Fix / Troubleshooting
Safety first: Unplug the appliance before removing the top or rear panels.
Steps to check:
- Verify leveling: Ensure the unit is level and all feet are firmly on the floor. Excessive vibration can trigger sensor errors.
- Locate vibration sensor: Remove the top panel and locate the vibration sensor (often mounted on the side or front frame). Check that it is securely fastened.
- Inspect wiring: Ensure the sensor connector is tight and wires are not pinched or cut.
- Test spin: After reassembly, run a spin-only cycle with a small load to see if 8E returns.
When to stop: If 8E persists, the vibration sensor or PCB may need replacement. This is a moderate repair; consider professional service.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Vibration Sensor (VRT Sensor)
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements