Washer-dryer combo displays LE1 and stops operation, often with water in the base pan.
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Possible Causes
How to Fix / Troubleshooting
Safety first: Disconnect power and water supply. Water in the base can contact live components if power is restored prematurely.
Steps to address:
- Remove base water: If accessible, remove the lower front or rear panel and soak up any water in the base tray. Allow the area to dry completely.
- Inspect float switch: Locate the float switch in the base (small device with a float or lever). Ensure it moves freely and is not stuck in the up position.
- Check for active leaks: Run a short fill cycle while observing the internal hoses, pump, and tub for drips. Stop immediately if a leak is seen and repair or replace the leaking component.
- Test again: After repairs and drying, restore power and run a normal cycle to confirm LE1 is cleared.
When to stop: If you cannot access the base or identify the leak, professional service is required to prevent water damage and electrical hazards.