Door lock error during drying phase; machine may stop mid-cycle with E16

Safety first: Unplug the appliance and allow it to cool before working near the door lock.

Step-by-step checks:

• 1. Check door lock wiring:
  • Access the door lock via the front seal.
  • Inspect the connector and wires for heat damage or looseness.
• 2. Test door lock contacts:
  • With the lock removed, use a multimeter to verify that the lock switches change state when the latch is engaged.
  • If contacts are intermittent, replace the door lock.
• 3. Ventilation and overheating:
  • Ensure condenser and air paths are clean to prevent excessive cabinet temperature.

When to call a technician: If E16 persists after lock replacement, the control module may require professional evaluation.