SMEG
Drum Bearing Failure
Washer-dryer is very noisy during spin; loud rumbling or grinding sound from the rear.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Worn rear drum bearings, Failed bearing seal allowing water ingress, Damaged drum spider, Misaligned drum shaft
How to Fix / Troubleshooting
Safety first: Unplug the appliance. Excessive bearing wear can lead to leaks and further damage.
- Check drum play: With the door open, lift the drum up and down. Excessive movement or roughness indicates bearing wear.
- Spin test: Rotate the drum by hand. A grinding or rumbling noise from the rear confirms bearing issues.
- Limit use: Avoid continued use as it can damage the tub and motor.
- Professional repair: Bearing replacement on SMEG washer-dryer combos usually requires tub removal and sometimes tub replacement. This is a complex job best handled by an experienced technician.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Drum Bearing Kit
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements