Speed Queen
Tub Bearing or Drive System Failure
Loud grinding or roaring noise during spin
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Worn rear tub bearings, Failed tub seal allowing water into bearings, Damaged drive pulley, Worn drive belt
How to Fix / Troubleshooting
Safety first: Unplug the unit. Spinning components can be hazardous.
- 1. Isolate noise: Run a spin-only cycle and listen from the rear and front to locate the noise source.
- 2. Drum rotation test: Spin the drum by hand with power off. A rough, rumbling feel suggests bearing failure.
- 3. Inspect pulley and belt: Remove the rear panel and check the drive pulley and belt for damage. Tighten pulley bolt and replace belt if worn.
- 4. Bearing/tub replacement: If bearings are noisy, the rear tub assembly or bearing kit must be replaced. This is a major repair often best handled by a professional.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Rear Tub Bearing Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements