E10
Teka
Water Level Detection Error
Washer-dryer shows E10 and may not proceed with cycle; often related to water level or fill issues.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Loose or damaged pressure switch hose, Faulty pressure switch, Blocked air trap on tub, PCB analog input fault
How to Fix / Troubleshooting
Safety first: Disconnect from mains and close water taps.
- Inspect pressure hose and air trap: Remove top cover. Follow the small hose from the pressure switch to the tub. Remove and clean both ends, ensuring no detergent sludge or debris is blocking the air path.
- Check hose integrity: Replace the hose if it is brittle, cracked, or loose on its fittings.
- Test pressure switch: Use a multimeter to verify that the switch changes state when gentle pressure is applied via the hose. Replace if it does not respond.
Warning: If mechanical components are fine, the PCB may not be reading the sensor correctly. This requires professional diagnostics.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Pressure Switch
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements