Washer-dryer combo shows F35 and may not fill or may abort cycle shortly after starting.
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Possible Causes
How to Fix / Troubleshooting
Safety first: Disconnect power and be cautious of water in hoses.
Step-by-step checks:
- Locate analog pressure sensor: Typically a small electronic module with a hose and electrical connector near the top of the cabinet.
- Inspect and clear hose: Remove and clear the hose of any blockage. Check the air dome at the tub.
- Check wiring: Ensure the connector is fully seated and wires are not damaged.
When to replace: If hose and wiring are good, replace the analog pressure sensor with the correct Whirlpool part. If F35 persists, the main control board may be defective.
Repair Difficulty
Required Part
We may earn a commission from links on this page.