E32
Xiaomi
Pressure Calibration / Water Level Out of Range
Washer-dryer shows E32 and may overfill or underfill, water level inconsistent on Xiaomi combo washer-dryer.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Incorrect pressure sensor calibration, Blocked air trap on tub, Kinked pressure hose, Faulty Xiaomi pressure sensor
How to Fix / Troubleshooting
Safety first: Disconnect power and close water taps.
- 1. Clean air trap and hose: Access the pressure hose at the tub connection. Remove and clean the air trap area of sludge and detergent residue. Ensure the hose is not kinked.
- 2. Re-seat sensor: Remove and reinstall the Xiaomi pressure sensor connector to ensure good contact.
- 3. Perform control reset: Unplug the machine for 10 minutes, then reconnect. Some models may auto-recalibrate water level on the next cycle.
- 4. Replace sensor if needed: If E32 continues, install a new Xiaomi pressure sensor. If the issue persists even with a new sensor and clean hose, the control board may require service.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Xiaomi Electronic Pressure Sensor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements