E60
Xiaomi
General Dryer Heating Error
Washer-dryer shows E60 and drying performance is poor or absent on Xiaomi combo washer-dryer.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Partially blocked condenser or air duct, Failing Xiaomi dryer heater, Faulty dryer NTC sensor, Control board dryer relay fault
How to Fix / Troubleshooting
Safety first: Unplug the unit before cleaning internal ducts or testing components.
- 1. Clean condenser and filters: Remove and thoroughly clean the condenser unit and any lint filters. Ensure airflow paths are clear.
- 2. Avoid very large loads: Dry smaller loads to reduce strain on the dryer system.
- 3. Inspect dryer NTC sensor (advanced): Access the dryer air duct and locate the Xiaomi dryer temperature sensor. Ensure it is firmly attached and its connector is secure.
- 4. Test heater and thermostats: With a multimeter, check continuity of the dryer heater and thermostats. Replace any open components.
- 5. If E60 persists: The control board's dryer circuit may be defective and should be serviced by a professional.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Xiaomi Dryer NTC Temperature Sensor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements