E62
Xiaomi
Dryer Overheating
Washer-dryer shows E62, drying temperature too high, machine may stop drying early on Xiaomi combo washer-dryer.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Blocked condenser or exhaust duct, Failed high-limit thermostat stuck closed, Faulty dryer NTC sensor reading low, Control board not regulating heater correctly
How to Fix / Troubleshooting
Safety first: Unplug the appliance and allow it to cool before working on the dryer system.
- 1. Thoroughly clean condenser and ducts: Remove all lint from condenser, fan housing, and internal ducts. Restricted airflow is the most common cause of overheating.
- 2. Check ambient conditions: Ensure the machine has adequate ventilation around it and is not installed in a confined, hot space.
- 3. Inspect thermostats and NTC (advanced): Access the dryer heater housing and test the high-limit thermostat and NTC sensor for correct operation. Replace any faulty components with Xiaomi-approved parts.
- 4. If E62 recurs: The control board may be failing to regulate heater power and should be evaluated by a technician.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Xiaomi Dryer High-Limit Thermostat
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements