E32
Zanussi
Pressure Sensor Calibration / Out-of-Range Signal
Washer-dryer intermittently shows E32, may stop during fill or spin, water level seems inconsistent.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Incorrect pressure sensor reading, Air leak in pressure hose, Faulty pressure sensor, Control board misreading sensor
How to Fix / Troubleshooting
Safety: Unplug the appliance before inspection.
- Check for trapped air/water: Remove the pressure hose and blow gently through it to ensure it is clear. Refit securely.
- Inspect hose routing: Ensure the hose is not rubbing against sharp edges or pinched under the top cover.
- Reset appliance: Leave unplugged for 10 minutes, then run a short cycle to see if the error clears.
- Replace sensor: If E32 recurs, fit a new pressure sensor. Ensure the part number matches your Zanussi washer-dryer model.
If a new sensor does not resolve the issue, the main PCB may require replacement.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Pressure Sensor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements