E50
Zanussi
General Motor / Drive Fault
Washer-dryer shows E50; drum may not turn or may stop suddenly during wash or spin.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Worn carbon brushes (on brushed motors), Faulty motor tachometer, Loose motor connector, Defective motor winding
How to Fix / Troubleshooting
Safety: Unplug the appliance before accessing the motor.
- Check drum movement: Rotate the drum by hand. It should turn smoothly without grinding.
- Inspect motor connections: Remove the rear panel, locate the drive motor, and ensure the multi-pin connector is fully seated.
- Check carbon brushes: On brush-type Zanussi motors, remove the brushes and inspect their length. Replace if worn below manufacturer specification.
- Test tachometer: Measure resistance of the tachometer coil on the motor. Replace the motor if the tach coil is open or damaged.
If E50 persists after motor repairs, the motor control circuit on the PCB may be faulty.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Drive Motor Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements