E60
Zanussi
General Heating System Fault
Washer-dryer shows E60; drying or washing heating does not work properly.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed wash heater element, Faulty dryer heater, Defective NTC temperature sensor, Wiring fault to heater or sensor
How to Fix / Troubleshooting
Safety: Unplug the appliance and allow it to cool fully before touching any heater components.
- Determine which heater: Check if the issue occurs during wash heating, drying, or both.
- Test wash heater: Access the tub heater from the rear or front (depending on model) and measure resistance. Replace if open circuit or shorted to earth.
- Test dryer heater: Access the dryer heater assembly (usually at the rear or top) and measure resistance. Replace if faulty.
- Check NTC sensors: Measure resistance of the wash and dryer NTC sensors at room temperature and compare with specifications. Replace if out of range.
If heaters and sensors are good, the PCB heater relay or triac may be defective and require professional replacement.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Wash Heater Element
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements