Washer-dryer shows E62; water overheats during wash, possible very hot drum or steam.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Shorted heater relay on PCB, Faulty wash NTC sensor reading too low, Stuck heater contact, Wiring short energising heater

Safety: Unplug the appliance immediately and allow it to cool completely.

Inspect NTC sensor: Replace the wash temperature sensor if it reads incorrectly at room temperature.
Check heater relay: If the heater remains energised when it should be off, the PCB relay may be stuck. Replace the main control board.
Inspect wiring: Look for signs of short circuits or melted insulation near the heater terminals.

Because overheating can be a fire risk, do not use the appliance until the fault is fully resolved.

Professional Required 5/5

Wash NTC Temperature Sensor

Check Price on Amazon

We may earn a commission from links on this page.