Zanussi
Overheating Component / Electrical Burning
Washer-dryer emits a burning smell or visible smoke during operation, with or without error codes.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Slipping or jammed drive belt, Foreign object between drum and tub, Overheating motor, Shorted wiring or connector
How to Fix / Troubleshooting
Safety: Immediately switch off and unplug the appliance. Do not continue to use it until the cause is found.
- Inspect belt and pulley: Remove the rear panel and check if the belt is slipping or misaligned, causing rubber burning smell. Replace belt if glazed or damaged.
- Check for obstructions: Look for items trapped between drum and tub causing friction.
- Inspect wiring: Examine harnesses and connectors for burn marks, especially near the motor, heater, and PCB.
- Do not ignore: If you cannot clearly identify and correct the source, contact a professional, as fire risk is present.
Advertisements
Repair Difficulty
Professional Required
5/5
Advertisements