Washer displays F34 and door may not lock at the start of cycle

Safety first: Unplug the washer before working on the door area.

Step-by-step checks:

• 1. Inspect latch and strike: Check for physical damage or misalignment. Tighten loose screws and replace broken parts.
• 2. Clean latch area: Remove detergent residue or debris that may prevent full engagement.
• 3. Access lock assembly: Remove the door boot clamp and pull back the gasket to reach the lock. Inspect and reseat the wiring connector.
• 4. Replace lock if needed: If the lock does not actuate when the cycle starts and tests open electrically, install a new door lock assembly.

When to call a technician: If a new lock does not resolve F34, the control output may be defective.