E32
Amica
Pressure Switch Calibration / Range Error
Washer shows E32 and may have issues with water level or spin on Amica washing machine.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Incorrect pressure switch fitted, Misadjusted or defective pressure switch, Blocked or leaking pressure hose, PCB calibration fault
How to Fix / Troubleshooting
Safety first: Unplug the washer before working on the pressure system.
- 1. Verify correct switch: If the pressure switch was recently replaced, confirm it is the exact Amica-specified part for your model.
- 2. Inspect hose and chamber: Remove the pressure hose and clean it and the tub air chamber thoroughly. Replace the hose if it shows signs of wear or leaks.
- 3. Test switch operation: Gently apply pressure to the switch and listen for multiple clicks (for multi-level switches). Use a multimeter to confirm that the contacts change state at the expected pressure. Replace if faulty.
- 4. Check wiring and PCB: Ensure the harness is intact and properly connected. If E32 remains with a known-good switch and hose, the control board may require replacement.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Water Level Pressure Switch
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements