Washer shows E13; may be associated with water leakage into base or anti-flood system activation on some Beko models.

Safety first: Unplug the washer and turn off water supply. Be prepared for water in the base.

Step-by-step checks:

• Inspect base tray: Tilt the machine slightly backward and look underneath (or remove rear/bottom cover). If water is present in the base tray, dry it thoroughly with towels or a sponge.
• Locate the leak: Run a short fill cycle while observing the machine (panels removed if necessary). Check the door seal, dispenser hose, tub-to-pump hose, and drain hose for drips.
• Tighten or replace components: Tighten hose clamps, replace cracked hoses, and replace a torn door gasket if needed.

Do not bypass or disable any float or leak sensors; they are critical safety devices.