E67
Bosch
Control Module / Configuration Error
Washer displays E67; control board configuration or electronics fault
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted control software, Incorrect module coding, Power surge damage, Internal control board failure
How to Fix / Troubleshooting
Safety first: Unplug the washer for several minutes to fully discharge electronics.
- Power reset: After 5–10 minutes, reconnect power and try to start a simple cycle.
- Check supply quality: Ensure stable mains voltage and avoid using extension leads.
- Service mode re-coding: Some Bosch models require re-coding or parameter setting of a replacement control board using service tools; this must be done by an authorized technician.
- Replace control module: If E67 persists, the Bosch control module is likely defective and should be replaced and coded professionally.
Advertisements
Repair Difficulty
Professional Required
5/5
Advertisements