Washer shows D13 and stops; may occur when switching from wash to spin.

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Stuck relay on main PCB, Software glitch, Power surge damage, Faulty wiring to key components (motor, heater, pump)

How to Fix / Troubleshooting

Safety first: Unplug the washer.

Control reset:

Disconnect power for at least 10 minutes to allow the control to fully reset.
Plug back in and run a short cycle without laundry.

Inspect PCB:

Remove the top cover and access the main PCB.
Look for burnt relays, darkened areas, or swollen components.
Check that all connectors are firmly seated.

If D13 recurs and visible PCB damage is present, replace the main control board. If no damage is visible, further electronic diagnosis is recommended by a qualified technician.

Repair Difficulty

Hard 4/5

Required Part

Main Control Board (PCB)

Check Price on Amazon

We may earn a commission from links on this page.