Brandt Drum Bearing Failure

Washer makes a very loud rumbling or roaring noise during spin.

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Worn rear tub bearings, Failed tub seal allowing water into bearings, Loose drum pulley, Damaged spider arm

How to Fix / Troubleshooting

Safety first: Unplug the washer.

Check drum play:

Open the door and lift the drum up and down by hand. Excessive movement or grinding indicates bearing wear.

Inspect pulley:

Remove the rear panel and check that the drum pulley bolt is tight.

Repair options:

On many Brandt models, bearing replacement requires splitting the tub, pressing out old bearings and seal, and installing new ones. This is a major repair best done by an experienced technician.
In some cases, the entire rear tub half or complete tub assembly must be replaced.

Continuing to use the washer with failed bearings can cause further damage and leaks.

Repair Difficulty

Professional Required 5/5

Required Part

Drum Bearings and Seal Kit

Check Price on Amazon

We may earn a commission from links on this page.