E10
Fagor
Pressure Switch / Level Sensor Fault
Washer does not detect water level correctly; may stop with E10 or show erratic fill/drain behavior
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Defective electronic pressure sensor, Blocked pressure hose or chamber, Loose connector at pressure sensor, PCB analog input fault
How to Fix / Troubleshooting
Safety: Disconnect power.
- Check pressure hose: Remove the top cover, locate the pressure sensor, and inspect the hose for kinks, splits, or blockages. Clean or replace as needed.
- Clean air trap: At the tub connection, remove and clean the air trap of detergent sludge.
- Reseat connector: Disconnect and reconnect the sensor plug to ensure a solid connection.
- Replace sensor: If hose and trap are clear but E10 persists, replace the pressure sensor with a compatible Fagor part.
Persistent issues after sensor replacement may indicate a PCB fault, which usually requires professional service.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Electronic Pressure Sensor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements