E56
Frigidaire
Severe Motor Error / No Speed Feedback
Washer displays E56; severe motor error; no spin or tumble
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed drive motor, Failed tachometer sensor, Failed motor control board, Open wiring in motor circuit
How to Fix / Troubleshooting
Safety first: Unplug the washer before testing.
- Perform full motor circuit check: Inspect motor, tach sensor, and wiring harness for damage. Test motor windings and tach output with a multimeter as per service manual.
- Inspect motor control board: Look for burnt or cracked components. Replace if any damage is found.
- Replace motor if no tach or open windings: If the motor fails continuity or tach tests, install a new Frigidaire drive motor.
- Replace motor control if motor tests good: If the motor and wiring are good, replace the motor control board or main control (depending on design).
- Run diagnostic cycle: After repairs, enter the washer's diagnostic mode (per service manual) and run a spin test to confirm E56 is cleared.
Advertisements
Repair Difficulty
Professional Required
5/5
Advertisements