E95
Frigidaire
Internal Control Board Communication Fault
Washer shows E95; communication error between microprocessors on control board
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Defective main control board, Power surge damage, Manufacturing defect in control circuitry
How to Fix / Troubleshooting
Safety first: Disconnect power before handling the control board.
- Power cycle: Leave the washer unplugged for at least 5 minutes, then reconnect and see if E95 clears temporarily.
- Inspect board: Remove the main control board and look for visible damage such as burnt components or cracked solder joints.
- Replace main control board: E95 almost always requires replacement of the main control board with a new Frigidaire board.
- Surge protection: Consider using a surge protector to prevent future damage.
- Verify operation: After replacement, run a diagnostic cycle to confirm E95 is resolved.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements