Frigidaire
Drive Motor / Belt / Agitation Failure
Washer fills with water but will not agitate or tumble
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Broken or slipped drive belt, Failed drive motor, Faulty motor control board, Loose motor wiring connector
How to Fix / Troubleshooting
Safety first: Unplug the washer before accessing the rear panel or motor.
- Check drive belt: Remove the rear panel and inspect the belt between the motor and drum pulley. Refit if slipped off; replace if cracked or broken.
- Spin drum by hand: Ensure the drum turns freely. Binding indicates bearing or foreign object issues that must be addressed.
- Inspect motor wiring: Reseat the motor connector and check for burnt or loose pins.
- Test motor: Use a multimeter to check motor windings for continuity. Replace the motor if open or shorted.
- Check motor control board: If belt and motor are good, the motor control board may be faulty. Inspect and replace as needed.
- Run test wash: After repairs, run a short cycle to confirm proper tumbling.
Advertisements
Repair Difficulty
Hard
4/5
Advertisements