Washer displays E70 and may not fill correctly; water level seems wrong or cycles end prematurely.

Safety first: Unplug the washer before removing the top or rear panel.

• Inspect pressure hose: Locate the small rubber or plastic hose running from the tub/air dome to the pressure sensor. Check for kinks, cracks, or disconnections.
• Clear blockages: Detach the hose from the sensor and gently blow through it to ensure it is clear. If blocked with soap residue, rinse and reinstall.
• Check sensor connection: Ensure the electrical connector on the pressure sensor is fully seated and free of corrosion.
• Replace sensor: If the hose is intact and E70 persists, replace the water level/pressure sensor with a GE-compatible part.
• Control board diagnosis: If a new sensor does not fix the issue, the main control board may be faulty and should be checked by a professional.