Washer displays E80 and may not advance through cycles; timing seems erratic.

Safety first: Unplug the washer before accessing controls.

• Power reset: Disconnect power for 10 minutes, then plug back in. Attempt to run a basic cycle (e.g., Normal) without options.
• Avoid interruptions: Do not frequently pause/unplug mid-cycle, as this can confuse the control logic.
• Check selector knob: If your GE Profile uses a rotary knob, ensure it is not loose or cracked and that it aligns correctly with cycle markings.
• Inspect control board: Remove the control panel and check for loose connectors or visible damage on the main board.
• Replace control board: If E80 persists and wiring is intact, the main control board may need replacement. This is typically a technician-level repair.