E98
GE Profile
Unknown / General Control Error
Washer shows E98 and may not start or may stop with no other obvious issue.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Intermittent control board fault, Firmware glitch, Unspecified sensor error, Electrical noise or interference
How to Fix / Troubleshooting
Safety first: Unplug the washer before inspection.
- Power cycle: Disconnect power for 10–15 minutes, then plug back in and run a small test load.
- Check installation: Ensure the washer is not sharing a circuit with large inductive loads (e.g., air compressors) that can introduce electrical noise.
- Inspect wiring: Look for loose or damaged harnesses, especially around the motor, door lock, and sensors.
- Service call: If E98 recurs, schedule service. A technician can use GE-specific diagnostics to pinpoint the underlying fault, which may require control board replacement.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements