How to Fix / Troubleshooting

Safety: Unplug the washer before removing any panels.

Check detergent use: Make sure you are using HE (high-efficiency) detergent and not exceeding the recommended dose. Over-foaming can confuse the pressure sensor.
Inspect pressure hose: Remove the top cover of the Gorenje washer (usually 2–3 screws at the back). Locate the small rubber hose running from the bottom of the tub/air chamber to the pressure switch. Check for kinks, blockages, or splits. Blow gently through the hose to clear any soap residue.
Check pressure switch connection: Ensure the electrical connector on the pressure switch is firmly seated and free of corrosion.
Visual check of air chamber: At the tub end of the hose, inspect the plastic air chamber for heavy soap scum or lint buildup; clean if accessible.

If F2 remains, the pressure switch or main control module may be defective and should be tested and replaced by a technician.

Washer stops mid-cycle or will not start, display shows F2, drum does not fill correctly.

Possible Causes