E18
Hoover
Drainage / Pump Feedback Error
Hoover washer displays E18 and may not drain or may stop mid-cycle.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Partially blocked pump, Faulty pump tachometer or feedback (if fitted), Loose pump wiring, PCB misreading pump status
How to Fix / Troubleshooting
Safety first: Unplug the appliance and prepare for water spillage when opening the pump filter.
- 1. Clean pump filter and housing: As with E03, remove and thoroughly clean the pump filter and check for obstructions in the impeller area.
- 2. Check pump impeller: Ensure the impeller spins freely and is not loose on the shaft. A wobbly or seized impeller indicates pump failure.
- 3. Inspect wiring: Check the pump connector and wiring harness for corrosion or loose contacts.
- 4. Replace pump: If the pump is noisy, intermittent, or has a damaged impeller, replace it with a Hoover-compatible drain pump.
- 5. If E18 persists: The PCB may not be reading pump feedback correctly; professional diagnosis is recommended.
Advertisements
Repair Difficulty
Medium
3/5
Advertisements