Washer displays F30 and may not dispense detergent or softener correctly.

Safety First: Unplug the washer before removing the dispenser assembly.

Step-by-step checks:

• Clean drawer: Remove the detergent drawer and thoroughly clean all compartments and siphon caps. Remove any hardened detergent or softener.
• Inspect housing: Check the dispenser housing for buildup blocking water flow.
• Check dispenser motor: Access the top of the dispenser housing and locate the dispenser motor or diverter. Verify the wiring is intact and the motor is not jammed.
• Test motor: With a multimeter, test the motor for proper resistance. If accessible, apply test voltage per service manual to confirm movement.

When to replace: Replace the dispenser motor or entire dispenser assembly if the motor is seized or open. Persistent F30 with good components may indicate a control board issue.