Washer displays E60 and will not heat water or stops during heating phase.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Failed heater, Faulty NTC sensor, Heater relay failure on PCB, Wiring fault in heating circuit

Safety first: Unplug the washer and ensure no water is present around electrical connections.

Inspect heater wiring: Access the heater terminals at the bottom of the tub and check for loose or burnt connectors.
Test heater and NTC: Measure resistance of the heater and NTC sensor. Replace any component out of specification.
Check PCB heater relay: Listen for a click when the machine should start heating (requires powered testing by a professional). If the relay does not operate or is burnt, replace the PCB.

Professional Required 5/5

Tub Heating Element

Check Price on Amazon

We may earn a commission from links on this page.