Washer will not start, displays F22, door will not lock or cycle ends immediately after pressing start.

Safety first: Unplug the washer before accessing the door lock. Do not pry the door open with tools.

Step-by-step:

• Check door closure: Ensure the door closes fully and latches. Look for clothing or gasket folds preventing full closure.
• Inspect door strike: Examine the plastic strike on the door for cracks or looseness. Tighten or replace if damaged.
• Access door lock: Remove the top panel and locate the door lock on the inside of the front panel. On some models, remove the front panel or door boot clamp for better access.
• Check wiring: Verify the harness connector is fully seated in the door lock and that no wires are broken.
• Replace door lock: If the lock does not click when starting a cycle, or is physically damaged, replace the door lock assembly with the correct Maytag part.
• Test: Reassemble, plug in, and run a quick cycle to confirm proper locking and unlocking.