How to Fix / Troubleshooting

Safety First: Unplug the washer and shut off water supply before servicing.

Step 1 – Locate pressure hose: Remove the top or rear panel. Find the small rubber or plastic hose running from the tub air dome to the control or pressure switch.
Step 2 – Inspect hose condition: Check for cracks, pinholes, kinks, or disconnections. Replace if damaged.
Step 3 – Clear blockages: Detach the hose from both ends and blow through it. If restricted, flush with warm water and reinstall. Ensure the air dome port on the tub is not clogged with detergent residue.
Step 4 – Reseat connections: Firmly reconnect the hose at both the tub and control ends, ensuring a tight seal.
Step 5 – Test operation: Restore power and run a small load. Monitor fill and water level behavior.

If the code returns and the hose system is clear and intact, the pressure sensor or main control board may be defective and require replacement.

Washer displays F1E3 and may not fill or start properly.

Possible Causes