E08
Rosières
Motor Drive Failure
Washer displays E08 and the drum does not turn at all during wash or spin.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Open-circuit motor windings, Failed motor triac or inverter module on PCB, Broken drive belt (on belt-driven models), Loose motor connector
How to Fix / Troubleshooting
Safety first: Unplug the washer before removing any panels.
Step-by-step checks:
- Check the belt: Remove the rear panel. Inspect the drive belt between the motor and drum pulley. If it is off, frayed, or broken, replace it with the correct Rosières belt and ensure correct tension and alignment.
- Inspect motor connector: Ensure the motor plug is fully seated and free of corrosion or burning. Reseat the connector.
- Test motor windings: With a multimeter, measure resistance between motor terminals according to the wiring diagram. Open circuits or very uneven readings indicate a faulty motor.
- Visual PCB check: If accessible, inspect the main control board for burnt components in the motor drive area. Do not attempt component-level repair unless qualified.
Warning: Motor and PCB faults involve mains voltage and high currents. If you are not experienced with electrical diagnostics, contact an authorized technician.
Advertisements
Repair Difficulty
Hard
4/5
Advertisements