Washer displays E10 and does not take in water at the start of the cycle.

Safety first: Unplug the washer and close the water tap before disconnecting hoses.

Step-by-step checks:

• Confirm tap operation: Open the water tap feeding the washer fully. Disconnect the hose from the washer and briefly open the tap into a bucket to confirm strong flow.
• Clean filters and hose: As in E02, remove and clean the mesh filters and flush the hose.
• Check valve coil: Access the inlet valve from the top. Inspect connectors and test coil resistance with a multimeter. Replace the valve if the coil is open or shorted.

Note: After reassembly, run a quick wash to confirm proper filling.