Top-load washer displays DC1; lid lock error persists even with no load.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Failed lid lock solenoid, Broken lid lock wiring harness, Control board output fault

Safety: Disconnect power.

Inspect wiring: Access the lid lock assembly under the top panel. Check for pinched or broken wires.
Test lock: With a multimeter, test the lock coil for continuity. Replace if open.
Replace assembly: Install a new lid lock if defective. If a new lock does not clear DC1, the main PCB may require replacement by a technician.

Hard 4/5

Lid Lock Assembly

Check Price on Amazon

We may earn a commission from links on this page.