Washer displays dE1; door appears closed but cycle will not start.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Internal failure of door lock switch, Loose wiring harness at door lock, Bent door strike not engaging switch fully

Safety: Disconnect power.

Check harness: Access the door lock assembly and ensure the connector is fully seated and wires are not damaged.
Inspect strike alignment: Close the door slowly and observe if the strike enters the lock straight. Adjust hinges or replace strike if bent.
Replace lock: If wiring and alignment are good, replace the door lock assembly.

Medium 3/5

Door Lock Assembly

Check Price on Amazon

We may earn a commission from links on this page.