Washer displays LE1 and stops; often associated with water detected in the base.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Water leak into base pan, Faulty leak sensor, Loose internal hose connection, Overfilling due to water level sensor fault

Safety: Disconnect power and water supply.

Remove lower panel: Access the base pan and inspect for standing water.
Dry base: Use towels or a wet/dry vacuum to remove all water. Allow components to dry completely.
Identify leak source: Run a fill-only test while observing hoses, pump, and tub gasket. Repair or replace any leaking component.
Check leak sensor: Inspect the leak sensor or float switch wiring and mounting. Replace if corroded or stuck.

Hard 4/5

Leak Sensor / Float Switch

Check Price on Amazon

We may earn a commission from links on this page.